Water chillers and air-water heat pumps with axial fans
- Frame: in galvanised sheet and coated with polystyrene powders (RAL 9003) at 180 °C.
- Panels: easy to remove allowing full access to internal components.
- Compressor: revolving spiral scroll hermetic compressor (2 in TANDEM configuration for mod. 482, 552 and 602).
- Condenser: consisting of a coil with copper tubes and aluminium fins with large exchange surface. The fin block is protected by a metal mesh.
- Fans: axial fans directly coupled to the 6-pole electric motor with external rotor, protection grade IP 54.
- Evaporator: with brazed plates in AISI 316 stainless steel, insulated with a casing in closed cell foam material.
- Condensation control: (standard) with pressure transducer.
- Protections: on hydraulic and cooling circuit.
- Electrical panel: equipped with general disconnecting device, auxiliary and power circuit protection, compressor remote control switch.
- Microprocessor: with main functions shown on display, equipped with selfadjusting regulator to allow optimal operation in case of low water content in the system.
- Test: the units are tested in the factory and supplied with oil and refrigerant.
VERSIONS ON REQUEST
- Pump only (REVERSIBLE versions).
- Pump and Tank (ONLY COLD versions).
ELECTRIC ACCESSORIES ON REQUEST
- Serial interface RS485.
- Operation clean contacts.
- Soft starter.
- Set point compensation according to outside air temperature.